Court of Appeals for the D.C. Circuit February 23, 2018, 16-1356 (Airmotive Eng'g Corp. v. Fed. Aviation Admin.)

Also known as

United States · · · 23-02-2018

United States Court of Appeals

FOR THE DISTRICT OF COLUMBIA CIRCUIT

Argued December 4, 2017 Decided February 23, 2018

No. 16-1356

AIRMOTIVE ENGINEERING CORPORATION AND ENGINE

COMPONENTS INTERNATIONAL, INC.,

PETITIONERS

v.

FEDERAL AVIATION ADMINISTRATION,

RESPONDENT

On Petition for Review of an Order

of the Federal Aviation Administration

Laura G. Ferguson argued the cause for petitioners. With

her on the brief was Andrew D. Herman.

Laura Myron, Attorney, U.S. Department of Justice,

argued the cause for respondent. With her on the brief were

Charles W. Scarborough, Attorney, and Paul M. Geier,

Assistant General Counsel for Litigation, U.S. Department of

Transportation.

Before: HENDERSON and ROGERS, Circuit Judges, and

SENTELLE, Senior Circuit Judge.

Opinion for the Court filed by Circuit Judge ROGERS.

2

ROGERS, Circuit Judge: A manufacturer of replacement

aircraft parts petitions for review of an “airworthiness

directive” issued by the Federal Aviation Administration that

mandates removal of some of its engine cylinder assemblies.

The manufacturer challenges the application of a risk

management methodology and whether there was substantial

evidence in the record to support the conclusion that the

cylinders presented an “unsafe condition” under agency

regulations. It also contends that a failure to analyze the risks

associated with replacement itself undermined reasoned

decisionmaking. It seeks a remand for a new risk assessment

of the cylinder assemblies. For the following reasons, we deny

the petition for review.

I.

In support of the mandate to “promote safe flight of civil

aircraft,” the Federal Aviation Administration (“FAA”)

promulgates safety standards for aircraft and component parts.

49 U.S.C. § 44701 et seq. To produce replacement parts for

aircraft engines, a manufacturer is required to obtain a “parts

manufacturer approval” (“PMA”), 14 C.F.R. § 21.301–.320,

that the part “conforms to its approved design and is in a

condition for safe operation,” id. § 21.

Read the full text

This document is published by courtlistener.com.

Moonlit adds the citation network, article-level links and cross-references, which are available to search for free.